Have a transceiver with an intermittent condition or just want a brand new relay to replace that aged one?  Eliminate a potential relay problem and help put that classic back into "good as new" condition with one or two brand new, direct replacement, relays.   

This new relay, part number 69-35NP, has been tested to be a direct plug-in replacement to the original Heathkit 69-35 relays used in the above rigs.  (Not for use with the HW-100 or HW-101 since they require a relay which has a mounting screw on it's base.) 

These are not Heathkit relays, but are fresh, newly made relays by a major manufacturer and have been tested to work fine in these three transceivers.   Relays may differ slightly in appearance from pictures above.  

Brand new shinny contacts and plug-in terminals!  You should never have to worry about a relay problem for another 30 years with these relays.  

NOTE:  The two relays in these radios have their energizing coils connected in series.  Thus, one relay can affect the operation of the other.  If you have standard 69-35 relays in your radio, there should be no problem in replacing just one with our new 69-35NP, unless the other relay is bad.  However, a lot of the original 69-35 relays were replaced with various other relays over the years because a new 69-35 was impossible to find.  Some of those replacements had coils with a much different resistance than the original 69-35 coil, and may not work properly with the new 69-35NP relay.  It is advisable to replace both relays if replacing just one would leave a non-standard relay in the circuit.

Order part number 69-35NP from the parts page.  

$15.00 each, or 2 for $27.00, plus S & H.

These could also be used with sockets in the HW- transceivers that use this same relay but would require a modification to the chassis to provide the rectangular socket opening mentioned above.  

Order part number 434-143 from the parts page.